HYDRAULIC / HYDROSTATIC SYSTEM (CONTâ€™D) Removing And Replacing Case Drain Filters For the correct service interval SCHEDULE on Page 10-70-1.)
Hydraulic fluid escaping under pressure can have sufficient force to enter a personâ€™s body by penetrating the skin. This can cause serious injury and possible death if proper medical treatment by a physician familiar with this injury is not received immediately.
Raise the operator cab. (See Raising on Page 10-30-2.) Figure 10-120-6
Check the fluid level in the reservoir and add as needed. (See Checking And Adding Fluid on Page 10-120-1.)
Disconnect the hoses and fittings at the ends of both case drain filters (Item 1) [Figure 10-120-6]. Remove the mounting clamp (Item 2) [Figure 10-120-6] from the filters. Install fittings on new filters. Install new filters, install mounting clamp. Reconnect and tighten hoses.
WARNING AVOID INJURY OR DEATH Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Failure to use care around combustibles can cause explosion or fire which can result in injury or death. W-2103-0807
Lower the operator cab. (See Lowering on Page 10-303.) Start the engine and operate the loader hydraulic controls. Stop the engine and check for leaks.
T140 Service Manual