HYDRAULIC / HYDROSTATIC SYSTEM (CONTâ€™D) Removing And Replacing Hydraulic Fluid For the correct service interval SCHEDULE on Page 10-70-1.)
Replace the fluid if it becomes contaminated or after major repair. Always replace the hydraulic / hydrostatic filter, the case drain filters and the hydraulic charge filter whenever the hydraulic fluid is replaced. (See Removing And Replacing Hydraulic / Hydrostatic Filter on Page 10-1203.)
Disconnect the hose (Item 1) [Figure 10-120-4] from the hydraulic reservoir and drain the fluid into a container. Reconnect the hose when reservoir is empty.
Recycle or dispose of used fluid in an environmentally safe manner.
Remove the fill cap (Item 1) [Figure 10-120-3].
AVOID INJURY OR DEATH Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil. Failure to use care around combustibles can cause explosion or fire which can result in injury or death. W-2103-0807
Raise the operator cab. (See Raising on Page 10-30-2.)
Lower the operator cab. (See Lowering on Page 10-303.) Add the correct fluid to the reservoir until the fluid level is at the top mark on the dipstick. (See Checking And Adding Fluid on Page 10-120-1.)
T140 Service Manual