HYDRAULIC / HYDROSTATIC SYSTEM (CONTâ€™D) Removing And Replacing Hydraulic Case Drain Filters (Single Speed Loaders)
See the SERVICE SCHEDULE for the service interval. (See SERVICE SCHEDULE on Page 10-70-1.) Figure 10-120-5 Left Side Shown 1 1 P-45499
Remove the case drain filter assemblies (Item 1) [Figure 10-120-6] near the hydrostatic motors. Install the fittings from the old filter assembly onto the new filter assembly. Install motor covers. Recycle or dispose of used fluid in an environmentally safe manner.
Remove both hydrostatic motor covers (Item 1) [Figure 10-120-5].
Start the engine and operate the loader hydraulic controls. Stop the engine and check for leaks at the filter assemblies. Check the fluid level in the reservoir and add as needed. (See Checking And Adding Fluid on Page 10-30-1.)
S150, S160 Service Manual