HYDRAULIC / HYDROSTATIC SYSTEM
Hydraulic / Hydrostatic Fluid Chart
Checking And Adding Fluid
Figure 10-120-2
Use only recommended fluid in the hydraulic system. (See HYDRAULIC/HYDROSTATIC FLUID SPECIFICATIONS on Page SPEC-40-1.) Put the loader on a level surface. Lower the lift arms and tilt the Bob-Tach fully back. Stop the engine. Figure 10-120-1
P-64023A
1 1
P-45224A P-45224C
Use the correct hydraulic / hydrostatic fluid shown in hydraulic / hydrostatic fluid chart [Figure 10-120-2].
2
P-48011
Check the fluid level in the sight gauge (Item 1) [Figure 10120-1]. Open the rear door and raise the rear grill. Remove the fill cap (Item 2) [Figure 10-120-1]. Add fluid as needed to bring the level to the center of the sight gauge (Item 1) [Figure 10-120-1]. Install the fill cap (Item 2) [Figure 10-120-1]. Lower the rear grill and close the rear door.
10-120-1
S150, S160 Service Manual