Page 1


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

COMPONENT LOCATION INDEX

Fig. 1: Identifying SRS Components Location (1 Of 2) Courtesy of AMERICAN HONDA MOTOR CO., INC. MY Friday, April 03, 2009 4:06:47 4:06:20 PM

Page 1

© 2005 Mitchell Repair Information Company, LLC.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

Fig. 2: Identifying SRS Components Location (2 Of 2) Courtesy of AMERICAN HONDA MOTOR CO., INC.

PRECAUTIONS AND PROCEDURES GENERAL PRECAUTIONS

Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this information, or the airbags could accidentally deploy and cause damage or injuries. 

Except when performing electrical inspections, always turn the ignition switch OFF, ground the SCS line with the HDS to take the PCM out of active status, disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. NOTE:

The SRS memory is not erased even if the ignition switch is turned OFF or the battery cables are disconnected from the

MY Friday, April 03, 2009 4:06:21 PM

Page 2

© 2005 Mitchell Repair Information Company, LLC.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

battery. 



Use replacement parts which are manufactured to the same standards and quality as the original parts. Do not install used SRS parts. Use only new parts when making SRS repairs. Carefully inspect any SRS part before you install it. Do not install any part that shows signs of being dropped or improperly handled, such as dents, cracks or deformation.

Fig. 3: Inspecting SRS Parts Courtesy of AMERICAN HONDA MOTOR CO., INC. 





Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS connector. Use only a digital multimeter to check the system. If it is not a Honda multimeter, make sure its output is 10 mA (0.01 A) or less when switched to the lowest value in the ohmmeter range. A tester with a higher output could cause accidental deployment and possible injury. Do not put objects on the front passenger's airbag.

MY Friday, April 03, 2009 4:06:21 PM

Page 3

Š 2005 Mitchell Repair Information Company, LLC.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey





The original radio and navigation system have a coded theft protection circuit. Be sure to get the customer's anti-theft codes and write down the radio station and XM channel presets before disconnecting the battery negative cable. After reconnecting the battery, reset the power sliding door control unit (see RESETTING THE POWER SLIDING DOOR CONTROL UNIT ), and reset the power tailgate control unit (see RESETTING THE POWER TAILGATE CONTROL UNIT ). Before returning the vehicle to the customer, enter the radio code, the navigation code, then enter the radio station and XM channel presets; set the clock.

STEERING-RELATED PRECAUTIONS Cable Reel Alignment 

  

Misalignment of the cable reel could cause an open in the wiring, making the SRS system, remote steering wheel controls, and the horn inoperative. Center the cable reel (see step 6 in INSTALLATION ), whenever the following is performed. - Installation of the steering wheel - Installation of the cable reel - Installation of the steering column - Other steering-related adjustment or installation Do not disassemble the cable reel. Do not apply grease to the cable reel. If the cable reel shows any signs of damage, replace it with a new one. For example, if it does not rotate smoothly, replace the cable reel.

AIRBAG HANDLING AND STORAGE

Do not disassemble an airbag. It has no serviceable parts. Once an airbag has been deployed, it cannot be repaired or reused. For temporary storage of an airbag during service, observe the following precautions. 

Store the removed airbag with the pad surface up. Never put anything on the airbag.

MY Friday, April 03, 2009 4:06:21 PM

Page 4

Š 2005 Mitchell Repair Information Company, LLC.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

Fig. 4: Storing Removed Airbag With Pad Surface Up Courtesy of AMERICAN HONDA MOTOR CO., INC. 

To prevent damage to the airbag, keep it away from any oil, grease, detergent, or water.

MY Friday, April 03, 2009 4:06:21 PM

Page 5

© 2005 Mitchell Repair Information Company, LLC.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

Fig. 5: Keeping Airbag Away From Oil, Grease, Detergent Or Water Courtesy of AMERICAN HONDA MOTOR CO., INC. 

Store the removed airbag on a secure, flat surface away from any high heat source (exceeding 200°F/ 93°C).

MY Friday, April 03, 2009 4:06:21 PM

Page 6

© 2005 Mitchell Repair Information Company, LLC.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

Fig. 6: Do Not Store Airbag Near High Heat Source Courtesy of AMERICAN HONDA MOTOR CO., INC.  

Never perform electrical inspections to the airbags, such as measuring resistance. Do not position yourself in front of the airbag during removal, inspection, or replacement.

MY Friday, April 03, 2009 4:06:21 PM

Page 7

© 2005 Mitchell Repair Information Company, LLC.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

Fig. 7: Precaution During Airbag Removal, Inspection Or Replacement Courtesy of AMERICAN HONDA MOTOR CO., INC. 



For proper disposal of a damaged airbag, refer to airbag disposal (see AIRBAG DISPOSAL ). The side curtain airbag inflator assembly is a long, jointed part containing an inflator (A), a flexible bag (B), and an adapter pipe (C).

MY Friday, April 03, 2009 4:06:21 PM

Page 8

© 2005 Mitchell Repair Information Company, LLC.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

Fig. 8: Identifying Side Curtain Airbag Inflator Assembly Courtesy of AMERICAN HONDA MOTOR CO., INC. 

When removing or installing the side curtain airbag inflator assembly, never handle the adapter pipe.

SRS UNIT, IMPACT SENSORS, DRIVER'S SEAT POSITION SENSOR, FRONT PASSENGER'S WEIGHT SENSORS AND UNIT, REAR SAFING SENSOR, AND ROLL RATE SENSOR 



Be careful not to bump or impact the SRS unit, front impact sensors, side impact sensors, rear safing sensor, or roll rate sensor whenever the ignition switch is ON (II), or for at least 3 minutes after the ignition switch is turned OFF. During installation or replacement, be careful not to bump (by impact wrench, hammer, etc.) the area around the SRS unit, front impact sensors, the side impact sensors, rear safing sensor, or roll rate sensor. The airbags could accidentally deploy and cause damage or injury.

MY Friday, April 03, 2009 4:06:21 PM

Page 9

© 2005 Mitchell Repair Information Company, LLC.


Thank you very much for your reading. Please Click Here. Then Get COMPLETE MANUAL. NO WAITING

NOTE: If there is no response to click on the link above, please download the PDF document first and then click on it.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

Fig. 9: Precaution For Bump Around SRS Unit, Front Impact Sensors , Side Impact Sensors, Rear Safing Sensor Or Roll Rate Sensor Courtesy of AMERICAN HONDA MOTOR CO., INC. 

After a collision in which the airbags or seat belt tensioners were deployed, replace the SRS unit, front impact sensors, and other related components (see COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ). After a collision in

MY Friday, April 03, 2009 4:06:21 PM

Page 10

© 2005 Mitchell Repair Information Company, LLC.


2005 Honda Odyssey LX 2005-06 RESTRAINTS SRS (Supplemental Restraint System) - Odyssey

which a side airbag deployed, replace the side impact sensor on the deployed side and the SRS unit. After a collision in which a side airbag and a side curtain airbag deployed, replace the side impact sensors on the deployed side and SRS unit. After a collision in which the airbags or the side airbags did not deploy, inspect for any damage or any deformation on the SRS unit, front impact sensors, the side impact sensors, roll rate sensor and rear safing sensor. If there is any damage, replace the SRS unit and/or the sensors

Fig. 10: Precaution Of SRS Unit Courtesy of AMERICAN HONDA MOTOR CO., INC. 





Do not disassemble the SRS unit, front impact sensors, side impact sensors, driver's seat position sensor, front passenger's weight sensor unit, front passenger's weight sensors, rear safing sensor, or roll rate sensor. Turn the ignition switch OFF, disconnect the battery negative cable and wait at least 3 minutes before beginning installation or replacement of the SRS unit, or disconnecting the connectors from the SRS unit. Be sure the SRS unit, front impact sensors, side impact sensors, rear safing sensor and roll

MY Friday, April 03, 2009 4:06:21 PM

Page 11

Š 2005 Mitchell Repair Information Company, LLC.

Profile for 1631221

2005 HONDA ODYSSEY Service Repair Manual  

2005 HONDA ODYSSEY Service Repair Manual  

Profile for 1631221
Advertisement