TECHTCORNER
20
vprmag.com :: holiday buyers guide
KAYFUN 3.1 break down
1. 2mm Silica wick with .7x1mm Flat ribbon equilvant to 30 awg Kanthal wrap a 3-4 wrap roughly 1.0 ohms – 1.3 this is because of the insulators on the Kayfun are bound to melt if you go to low 2. Make sure you tight down the positive post with a flat head screwdriver hold the positive post and tighten with flathead 3. This is the positive post that needs to be tighten if this is loose this will short you device and cause problems. 4. Go head and mount the wick you created one leg should be pointed to the north and one leg should be pointed to the south it makes it easier to mount. 5. Once screws are tighten grab the loose ends and pull together so it will fit the
Evaporation chamber 6. Should look like this when tighten 7. Once you get the loops tight where the loop touches the grooves on the base cut the single ends off so just the 2 small loops are left after you do this you want to move the coil up from the air hole this will effect the air flow it could be tight. 8. Bend the 2 loops down and screw the evaporation chamber on 9. Then screw the collector-tank on and insert the screw (+) pin and o-ring in to the bottom collector-tank 10. Like so 11. At this time you could test fire it on your choice of device 12. At this point you could moist the wick with your favorite eJuice and then put the Chimney in the evaporation chamber
13. Screw on the body (Tank) to the base 14. you want to fill till the 2 thread from the bottom 15. Now screw the top cap on till you could see the rubber o-ring 16. Like so once you see only the o-ring at this point there is many ways of filling you could use the traditional way using the plastic filler if you still have it or your finger or what I use a banker rubber band to cover the air hole because you are trying to crate a vapor lock 17. This method works for me using a banker rubber band I always have some because it is my tool of the trade I use it to get other peoples flush mount atomizers off there device 18. Once upside down with o-ring from top cap is showing and rubber band covering the air hole start to tighten the top cap to snug turn it upside down and take a vape.
1.
11.
2.
12.
3.
13.
4.
15.
6.
16.
8.
17.
9.
18.
10.