Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat)
EEC Version;3.0 Feb..2005
Remove the carburetor; Remove the vacuum cover bolt and vacuum cover. Notice: Move slowly to prevent the spring from ejecting. g) Take out the spring, the vacuum membrane and the plunger; Press down the holding clamp of the needle valve top, and turn left to take out the clamp; Take out the spring and needle valve. Don’t damage the vacuum membrane. Inspection a) Inspect if the needle valve is worn or not. b) Inspect if there are damages on the vacuum membrane. c) Inspect if the plunger is damaged. Installation a) Assemble the plunger and vacuum membrane into the carburetor body. b) Push the plunger upwards in the direction of the vacuum chamber cover to make the carburetor jet tube totally open. c) Put the spring in. d) Align the bulge part of the vacuum membrane with the fillister of the carburetor body. e) Assemble the vacuum chamber cover; Tighten the bolt.
3.12 Inspection of Automatic Side Starter (Choke) a) Remove the fuel hose from the carburetor; Turn out the carburetor float chamber drain screw, and drain the fuel in the carburetor; Remove the automatic side starter lead wire and wire clip; Remove the carburetor clamp and carburetor; Check the connecting condition between the two lead wires. c) Check the choke value. It should be below 10â„Ś; if it exceeds the specific value, it should be replaced. d) When the engine is cold, link a hose on the reserve supply fuel line and blow very gently. If the auto side starter is abstracted, it is faulty and should be replaced. 38