FINISHING MATERIALS INSTALLATION All finishing PDWHULDOV WKDW VXUURXQG WKLV ILUHSODFHœV rectangle profile must extend out from the face surface of this fireplace 1 inch. Tiles and Faux Rock If installing Tiles or )DX[ 5RFN ILUVW LQVWDOO D ò´ WKLFN (minimum) Cement Board (Hardibacker or Durock Brand) over the face of the fireplace and framing members. Follow by applying Thinset mortar (no polymer additives) XVLQJ ó´ VTXDUH notched trowel on the cement board surface. Finally, install tile to reach a finish material depth of 1 inch. Marble and Granite Slabs If installing Marble or Granite slabs as fascia materials, specify that the inner edges that will be adjacent to the Glass Door DUH SROLVKHG 5RXJK )UDPLQJ VKRXOG EH FUHDWHG DW ´ GHSWK ZLWK WKH IURQW VXUIDFH RI WKLV ILUHSODFH SURWUXGLQJ RXW ò´ IURP WKH IUDPLQJ VXUIDFH ,QVWDOO ´ WKLFN GU\ZDOl on framing members so that its outer surface is flush with the front face of this fireplace. Attach Marble or Granite slabs to face of unit and to drywall surface using adhesive that does not offgas when hot. ,Q WKH DUHD GHILQHG DV ³121&20%867,%/( =21(´ [FIGURE 7], only NONCOMBUSTIBLE MATERIALS ARE ALLOWED. When this fireplace is installed in a framed cavity that is 19-1/2´ GHHS WKH IDFLQJ PDWHULDO ILQLVKLQJ JXLGH ZLOO SUotrude out into the room 1 inch. Build finishing materials to 1 inch thickness and use the built-in guides for edge alignment of fascia material. &RQVXOW VHFWLRQ ³)5$0,1* '(37+ DQG ),1,6+,1* *8,'(6´ DETAIL B SCALE 0.26 : 1 1.00 INCH
FACE OF FV-41
1" FINISHING GUIDE
WARNING: See Figure 7. The cross hatched areas labeled as ³121&20%867,%/( =21(´ PXVW EH FRYHUHG ZLWK QRncombustible finishing materials that is 1-inch thick, minimum. DO NOT ALLOW COMBUSTIBLE MATERIALS TO ENCROACH IN THIS AREA!
Figure 6: NON COMBUSTIBLE ZONE [ALL HATCHED AREAS]
15 | P a g e
NON-COMBUSTIBLE ZONE [ALL HATCHED AREAS]