Contour Connect Components
The Contour Connect Kit set Panels are designed for applications where the OEM or panel builder wishes to construct a custom system. They're supplied as empty panels with all necessary mounting hardware, including one CC-joiner.
The CC-1 module will house the following components.
CC-1
701-PM
Panel mount battery on/off (page 46).
701S-PM
Panel mount battery selector switch (page 46).
185 Series
Heavy duty circuit breakers (page 26).
(CC-HDBM must be ordered with 185 circuit breakers, one per breaker).
710-125A
Voltage sensitive relay (page 29).
710-125A-DS Voltage sensitive relay dual sense (page 49).
The CC-2 module will house the following components: CLB series (push reset) Carling circuit breakers (page 26). Toggle Magnetic Hydraulic Airpax Carling circuit breakers (page 25).
CC-2
The CC-3 module will house the following components: CLB series (push reset) Carling circuit breakers (page 26) Toggle Magnetic Hydraulic Airpax Carling circuit breakers (page 25)
CC-3
The CC-4 module is designed for different applications. Application One: For fitting insulated studs in back of panel to prewire assembled panel. (IS10MM-2). The CC-4 will also accept the 703-300A or 703-500A heavy duty bus bars (page 69) This can be used to terminate negatives at back of panel or for multiple outputs from battery switches. Application Two: For installing ancillary equipment associated with battery management area.
CC-4
The CC-5 module will house all the same components as the CC-1.
CC-5
60
LEADING ELECTRICAL DESIGN