Setting the Registration-mark Auto-scan mode If the registration marks are at pre-determined positions on the medium, they can be scanned automatically. When ON was selected
Registration-mark pattern 1
100mm
Medium feed direction
Point 4
Point 2
Registration-mark pattern 2
Point 2
Point 4
Point 1 (the desired Origin Point) Point 3 Point 1 (the desired Origin Point)
100mm
Point 3
Move the pen tip within this area
When OFF was selected
Move the pen tip within this area
Registration-mark pattern 1
Medium feed direction
Point 4
Point 2
Point 4
Point 2
Point 1 (the desired Origin Point) Point 3 Point 1 (the desired Origin Point)
Move the pen tip within this area
2
AUTO
(NEXT) or
(PREV.) key until the following menu is displayed.
REG. MARK
3
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the (PREV.) key until the following menu is displayed. MARK
Step
Step
(NEXT) or
AUTO SCAN
4 (ENTER) key to display the Auto-scan mode setting.
Press the AUTO
Y
(PAUSE) key to switch to PAUSE mode.
Press the
Step
Move the pen tip within this area
X
1
Press the
Step
Y
Registration-mark pattern 2
Point 3
Step
X
SCAN
ON
5
Press the or key to select “ON” or “OFF,” and then press the the selection, press the (NEXT) or (PREV.) key.
4 – 19
(ENTER) key to confirm. To cancel