Step
5
Press the (ENTER) key to return the pen carriage to its previous position and to switch the cutting plotter to READY mode.
Step
6
Adjust the CUTTER OFFSET value to suit the type and thickness of the medium being used, and fineadjust the finish of each corner. Set the FORCE so that only faint cutting lines remain on the base sheet when the blade length is properly adjusted.
CUTTER OFFSET is too low Increase (by +1 to +5)
Step
Correct CUTTER OFFSET setting
CUTTER OFFSET is too high Decrease (by -1 to -5)
7
Upon completion of fine adjustment, actual cutting data can be sent to the cutting plotter.
3 – 13