PRODUCT FOCUS
Revit MEP 2014
Figure 11 Figure 9
7. For each level, the upper limit for spaces must be changed. Select everything on a given level and use the Filter tool on the ribbon to select only the spaces. 8. In Properties, change the upper limits of the spaces to the Alvine Space Upper Limit Level. 9. Repeat steps 7 and 8 for each level with spaces.
With areas and volumes being calculated, a section through a space is still necessary to make sure the volume generated is what is really required. Image shows a typical space where the offset has not been set to a level higher than the sloped roof.
Spaces can be used just to annotate room and give areas, but if volumes are required, there is more to do. Figure 10 shows a section through a space where the offset for the space is above the building but volumes are not being calculated.
Figure 12
Figure 10
To ensure volumes are calculated, go to the Room panel of the Architectural tab and click the radio button next to Areas and Volumes.
February 2014
With areas and volumes being calculated, a section through a space is still necessary to make sure the volume generated is what is really required. www.augiworld.com
41